SUIGN02GBB2S, alarmy, schematy podłączeń alarmow w samochodach
[ Pobierz całość w formacie PDF ]
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
MAKE
SUZUKI
MOD.
IGNIS
YEAR.
02
2
nd
sem
.
fi
PETROL
DIESEL
X
ALARM/SIREN
POSITION
Position the compact alarms and the sirens on the support of the shock
absorber, driver’s side. Pass the cables through the original rubber sleeve
located in the bulkhead that divides the engine compartment and the driver’s side
passenger’s compartment , the same rubber sleeve of the bonnet opening wire.
CENTRAL UNIT POSITION
The modular systems and the modules should be positioned under the
dashboard, driver’s side.
POWER SUPPLY
+30:
connect to the 3 mm
2
RED wire located in a multiway connector, in the fuse
box.
-31:
connect to one of the ground terminal located behind the left lateral
bulkhead, driver’s side.
IGNITION WIRE
+15/54:
Connect to the YELLOW wire with SILVER references located in the
wiring harness behind the sill cover, driver’s side.
DIRECTION INDICATORS
Connect to the BLUE/YELLOW wire with SILVER references and to the
GREEN/RED wire with SILVER references located in the wiring harness behind
the driver’s side sill cover.
ELECTRIC WINDOWS
Positive control signal
Front window, driver’s side:
cut the the RED wire with SILVER references located in the wiring harness
coming out of the control switch, directly inside the driver’s side door.
Front window, passenger’s side:
cut the RED/WHITE wire with SILVER references, at the position nr. 7, coming
out of the 14 way white connector, located under the dashboard driver’s side, in
the upper part of the bulkhead.
CENTRAL DOORS LOCKING
Negative control signal
Connect to the BROWN/WHITE wire with SILVER references (unlock) and to the
BROWN wire with SILVER references (lock) in the 14 way white connector,
located in the upper part, under the driver’s side dashboard.
IMMOBILISATION POINT
Fuel pump
Cut the PINK wire with SILVER references located in the wiring harness behind
the sill cover, driver’s side.
STARTER
+50:
Cut the 1,5 mm
2
BLACK/YELLOW wire located in the 6 way white
connector, directly on the coming out of the ignition key.
BONNET SWITCH
Install an additional switch on the front headlamp support plate, driver’s side.
DOORS AND BOOT SWITCH
Connect to the BLACK/RED wire located in the wiring harness behind the
driver’s side sill cover.
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
suign02gbb2s.doc
[ Pobierz całość w formacie PDF ]