SULIA02GBB, alarmy, schematy podłączeń alarmow w samochodach
[ Pobierz całość w formacie PDF ]
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
MAKE
SUZUKI
MOD.
LIANA
YEAR.
02
fi
PETROL
DIESEL
X
ALARM/SIREN
POSITION
Position the compact alarms and the sirens on the bulkhead that divides the engine
compartment and the passenger’s compartment on the side of the servobrake.
CENTRAL UNIT POSITION
Position the modular systems and the modules under the dashboard, driver’s side.
POWER SUPPLY
+30:
connect to the WHITE/GREEN wire in the black connector coming out of the
ignition key.
-31:
connect to one of the ground terminals located behind the driver’s side
bulkhead.
IGNITION WIRE
+15/54:
connect to the YELLOW/BLACK wire in the black connector coming out of
the ignition key.
DIRECTION INDICATORS
Connect to the GREEN/REED/silver wire and BLUE/YELLOW/silver wire, in the 12
way grey connector, located on the connectors holder, under the driver’s side
dashboard, behind the fuse-holder box.
ELECTRIC WINDOWS
Negative controls
Front window, driver’s side:
cut the RED/silver wire in the push buttons panel, inside the driver’s side door.
Front window, passenger’s side:
cut the RED/WHITE/silver wire in the push buttons panel, inside the driver’s side
door.
Rear window, driver’s side:
cut the RED/YELLOW/silver wire located in the bundle of cables behind the driver’s
side sill cover.
Rear window, passenger’s side:
Cut the WHITE/RED/silver wire located in the bundle of cables behind the driver’s
side sill cover.
CENTRAL DOORS LOCKING
Negative control signal
Connect to the BROWN/WHITE wire, at the position nr.14 (lock) and to the
BLUE/ORANGE wire, at the position nr. 16 (unlock), located in the 18 way white
connector, on the connectors holder plate, under the driver’s side dashboard, behind
the fuse holder box.
IMMOBILISATION POINT
Fuel pump
Cut the PINK wire with two silver points, in the bundle of cables behind the driver’s
side sill cover.
STARTER
+50:
Cut the BLACK /YELLOW wire located in the wiring harness coming out of the
ignition key.
BONNET SWITCH
Install an additional switch on the front headlamp support plate, driver’s side.
DOORS AND BOOT
SWITCH
Connect to the BLACK/RED/silver wire, at the position nr.15, in the 18 way white
connector, on the connectors holder plate, under the driver’s side dashboard, behind
the fuse-holder box.
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
sulia02gbb.doc
[ Pobierz całość w formacie PDF ]