SUIMP96GBB, alarmy, schematy pl
[ Pobierz całość w formacie PDF ]
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
SUBARU
MOD.
IMPREZA
YEAR
96
fi
PETROL
DIESEL
X
MAKE
ALARM/SIREN
POSITION
Position the compact alarms and the sirens in the engine compartment, on the
panel of the wheel housing, passenger’s side.
The modular systems and the modules should be fixed on the left, under the
dashboard, driver’s side.
POWER SUPPLY
+ 30:
connect to the ground terminal at the entrance of the fuse box.
- 31:
connect with a cable terminal to the car body.
DIRECTION INDICATORS
Connect to the BLACK/GREEN and WHITE/RED wires located in the wiring
harness coming out of the 20 way blue connector, above the fuse box.
ELECTRIC WINDOWS
Positive control signal
Front window, driver’s side:
cut the 1,5 mm
2
BLUE wire.
Front window, passenger’s side:
cut the 1,5 mm
2
WHITE wire.
Rear window, driver’s side:
cut the 1,5 mm
2
WHITE/RED wire.
Rear window, passenger’s side:
cut the 1,5 mm
2
WHITE/BLUE wire.
The connections should be made in the wiring harness coming out of the 9 way
connector on the base of the driver’s side support.
CENTRAL DOORS LOCKING Additional motor
It is necessary to install a 2 wires motor on the driver’s side door.
IMMOBILISATION POINT
Fuel pump
Cut the 1,5 mm
2
YELLOW wire located in the wiring harness coming out of the
round fuel pump relay, above the fuse box.
BONNET SWITCH
Install an additional switch on the front headlamp support plate, in
correspondence with the left lateral headlamp.
DOORS AND BOOT SWITCH
Connect to the 1 mm
2
RED/GREEN wire located in the wiring harness coming out
of the 20 way white connector, above the fuse box.
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
suimp96gbb.doc
[ Pobierz całość w formacie PDF ]